Factory 42 Multi Layered Scrapbook Layout

Good Morning everyone,

Today I am pleased to be bringing you a multi layered layout using the incredible Factory 42 collection 

IMG_0883To start this layout I used the large Cogs and Pulleys Die Cut sheet and cut two sections from the edges and arranged them as seen. (You will end up with a piece from the middle that you could use on another project as you will not be using the entire sheet in this one.)

When firmly stuck I assembled several of the cogs and gears from the collectable pack and mounted them on two torn pieces of corrugated card and I then inked the ridges with the Vintage Ink Pad (I find this such a useful little Ink Pad..well worth having in your collection!)

I used the rust effect patina technique on a few of the cogs (please see my tutorial on my first September blog post HERE) and some of the pipes to tuck behind the photo too. I mounted the photo on a page from the Paper pad and used some stickers from the Sticker Sheet that I used within a Kaisercraft Wooden Veneer Frame.

IMG_0889I then arranged the bottom cluster and used a quote from the  Workshop Paper that I mounted on a piece from the Paper Pad too and mounted it on another piece of the inked corrugated card. IMG_0884

IMG_0885I finished with some more sayings and stickers from the collectable pack and added a few bronze rhinestones, some sequins and a few brass bits from my stash too.

IMG_0883

Thanks for looking..enjoy! 

Elaine

Leave a Reply

Your email address will not be published. Required fields are marked *